Chapter 4
Installing IDS-4235 and IDS-4250
Because of the size and weight of the rack cabinet doors, never attempt to remove or install them by
Warning
yourself.
Two-Post Rack Installation
You can install the two-post rack (part number IDS-RAIL-2=) in a center-mount or flush-mount
configuration. The two-post kit incorporates slide assemblies that enable the appliance to be pulled out
of the rack for servicing.
You must properly secure the two-post, open frame relay rack to the floor, the ceiling or upper wall, and
where applicable, to adjacent racks, using floor and wall fasteners and bracing specified or approved by
the rack manufacturer.
Warning
Do not attempt to install the appliance into a two-post, open-frame relay rack that has not been
securely anchored in place. Damage to the appliance and injury to yourself and to others may result.
This section contains these topics:
•
•
•
•
Recommended Tools and Supplies
You need the following tools and supplies to install the appliance in a two-post, open-frame relay rack:
•
•
•
Rack Kit Contents
The two-post rack kit includes:
•
•
•
•
•
•
78-16124-01
Recommended Tools and Supplies, page 4-27
Rack Kit Contents, page 4-27
Marking the Rack, page 4-28
Installing the Slide Assemblies in the Rack, page 4-28
#2 Phillips screwdriver
11/32-inch wrench or nut driver (if changing bracket to flush-mount configuration)
Masking tape or felt-tip pen to mark the mounting holes
One pair of slide assemblies (two-post)
One cable-management arm
One status-indicator cable assembly
Two stop blocks
Eight 12-24 x 0.5-inch pan-head Phillips screws
Releaseable tie wraps
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Installing the Accessories
4-27