Removing The Scsi Hard-Disk Drive - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Installing the Accessories
Figure 4-5
Figure 4-5
When you have installed the new hard-disk drive, you must reimage it with the recovery/upgrade CD.
For the procedure, refer
This section contains the following topics:
•
•

Removing the SCSI Hard-Disk Drive

To remove the SCSI hard-disk drive, follow these steps:
Log in to the CLI.
Step 1
Prepare the appliance to be powered off:
Step 2
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Note
Step 3 Power off the appliance by pressing the power button.
Step 4 Remove the front bezel.
For the procedure, see
Step 5 Open the hard-disk drive handle to release the drive.
Step 6 Slide the hard-disk drive out until it is free of the drive bay.
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
4-16
shows the SCSI hard-disk drive indicators.
SCSI Hard-Disk Drive
Drive power-on (green)
Green drive-activity indicator
Using the Recovery/Upgrade
Removing the SCSI Hard-Disk Drive, page 4-16
Replacing the SCSI Hard-Disk Drive, page 4-17
You can also power down the sensor from IDM.
Installing and Removing the Bezel, page
Chapter 4 Installing IDS-4235 and IDS-4250
CD.
4-10.
78-16124-01