Installation And Removal Instructions; Installing Aip-Ssm - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Chapter 6

Installing AIP-SSM

Installation and Removal Instructions

This section describes how to install and remove AIP-SSM, and contains the following topics:
•
•
•
Installing AIP-SSM
To install AIP-SSM, follow these steps:
Power off ASA.
Step 1
Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare
Step 2
skin. Attach the other end to the chassis.
For more information, see
Remove the two screws at the left back end of the chassis, and remove the slot cover.
Step 3
Insert AIP-SSM through the slot opening.
Step 4
Attach the screws to secure AIP-SSM to the chassis.
Step 5
Power on ASA by pushing the power switch at the back of the chassis.
Step 6
Check the indicators.
Step 7
If AIP-SSM is properly installed, the POWER indicator is solid green and the STATUS indicator is
flashing green. You can also verify that AIP-SSM is online using the show module command. For more
information, see
Step 8 Initialize AIP-SSM.
For the procedure, see
78-16124-01
Installing AIP-SSM, page 6-3
Verifying the Status of AIP-SSM, page 6-4
Removing AIP-SSM, page 6-5
Working in an ESD Environment, page
Verifying the Status of AIP-SSM, page
Initializing the Sensor, page
LI NK
SP D
LI NK
3
SP D
LI NK
2
SP D
LI NK
1 SP D
0
LI NK
6-4.
9-2.
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Installation and Removal Instructions
1-19.
FL AS H
SP D
LI NK
3
SP D
LI NK
2
SP D
LI NK
1 SP D
0
6-3