Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual page 58

Removing and Replacing the Chassis Cover
Note
Power off IDS-4215.
Step 3
Remove the power cord and other cables from IDS-4215.
Step 4
Place IDS-4215 in an ESD-controlled environment.
Step 5
For more information, see
Remove the screws from the back of the chassis.
Step 6
With the front of IDS-4215 facing you, push the top panel back one inch.
Step 7
Pull the top panel up and put it in a safe place.
Step 8
POWER
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
3-12
You can also power down IDS-4215 using IDM.
Working in an ESD Environment, page
Top panel screws (4)
100 Mbps Link
10/100 ETHERNE T 0/0
POWER ACT NETWORK
ACT NETWORK
FDX
100 Mbps Link FAILOVER
FDX
10/100 ETHERNE T 0/0
CONSOLE
Chapter 3 Installing IDS-4215
1-19.
CISCO IDS-4215
Intrusion Detection Sensor
CISCO IDS-4215
Intrusion Detection Sensor
78-16124-01