Cisco Ios Software; Resetting Idsm-2; Catalyst Software - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Chapter 7 Installing IDSM-2

Cisco IOS Software

Use the hw-module module module_number reset mem-test-full command to enable a full memory
test. The full memory test takes about 12 minutes.
To enable a full memory test, follow these steps:
Log in to the console.
Step 1
Enable the full memory test:
Step 2
router# hw-module module 9 reset mem-test-full
router#
Step 3 Reset IDSM-2.
The full memory test runs.
Note

Resetting IDSM-2

If for some reason you cannot communicate with IDSM-2 through SSH, Telnet, or the switch session
command, you must reset IDSM-2 from the switch console. The reset process requires several minutes.
This section describes how to reset IDSM-2, and contains the following topics:
•
•

Catalyst Software

To reset IDSM-2 from the CLI, follow these steps:
Step 1 Log in to the console.
Step 2 Enter privileged mode:
console> enable
Step 3 Reset IDSM-2 to the application partition or the maintenance partition:
console> (enable) reset module_number [hdd:1 | cf:1]
78-16124-01
Device BOOT variable for reset = <empty>
Warning: Device list is not verified.
Proceed with reload of module?[confirm]
% reset issued for module 9
A full memory test takes more time to complete than a partial memory test.
Catalyst Software, page 7-13
Cisco IOS Software, page 7-14
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Resetting IDSM-2
7-13