Use Cisco Ios Xe Cli-Manual Configuration - Cisco 4000 Series Hardware Installation Manual

Chapter 4 Configure Initial Router Settings on Cisco 4000 Series ISRs
•
Use Cisco IOS XE CLI—Manual Configuration
This section describes you how to access the command-line interface (CLI) to perform the initial
configuration on the router.
Note
If the default configuration file is installed on the router prior to shipping, the system configuration
dialog message does not appear, To configure the device, follow these steps:
Enter the appropriate answer when the following system message appears on the router.
Step 1
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]: no
Press Return to terminate autoinstall and continue with manual configuration:
Step 2
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2012 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Step 3 Press Return to bring up the Router> prompt.
...
flashfs[4]: Initialization complete.
Router>
Step 4 Type enable to enter privileged EXEC mode:
Router> enable
Router#
•
•
OL-32185-02
Password: password
Router# setup
Modify the existing configuration or configure additional features by using the CLI:
Router> enable
Password: password
Router# configure terminal
Router(config)#
To configure the initial router settings by using the Cisco IOS CLI, you must set up a console
connection.
Configure Cisco 4000 Series ISR Hostname, page 4-6
Configure the Enable and Enable Secret Passwords, page 4-7
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Perform Initial Configuration on Cisco 4000 Series ISRs
(Optional)
(Required)
4-5