Observe And Adjust Video; Acquire And Measure Data; Display And Measure With Reference To Ccrp - JRC JMA-9123-7XA Instruction Manual

>
JMA-9100 Instruction Manual 3.BASIC OPERATION
3.1.2

Observe and Adjust Video

Procedures
1) Press [RANGE+] key or [RANGE-] key to set the range to the
scale required for target observation.
[GAIN] [SEA] and [RAIN] to obtain the clearest targets.
2)
For how to adjust video, see Section 3.2 "OBSERVE AND ADJUST VIDEO"
3.1.3

Acquire and Measure Data

For details on how to acquire data and measure, see the SECTION
4"MEASUREMENT OF RANGE AND BEARING".
3.1.4

Display and Measure with Reference to CCRP

The radar video, range, bearing, Target Tracking and AIS data display etc... are
displayed with reference to CCRP (Consistent Common Reference Point).
If scanner is switched, these data are measured from CCRP.
If some kind of functions set scanner position to outside of the PPI range, these
data except Target Tracking and AIS data are displayed with reference to scanner
position.
For how to setting CCRP, see the Section 7.1.9 "Setting of CCRP (CCRP
Setting)".
>
3.1 OPERATION FLOW
Refer to
[GAIN] dial→ Section 3.2.4 "Adjust Gain [GAIN]"
[SEA] dial→ Section 3.2.5 "Suppress Sea Clutter [SEA]"
[RAIN] dial → Section 3.2.6 "Suppress Rain/Snow Clutter
[RAIN]"
for how to use each dial.
3－ 4