Target Acquisition; Automatic Acquisition - JRC JMA-7710-6 Instruction Manual

5.3

Target Acquisition

Attention
For automatic acquisition, please adjust the [SEA] or [GAIN] control properly to prevent pickup
such as sea clatter as much as possible.
For the method for target acquisition of this equipment, automatic and manual modes are available, but both
modes can be used at the same time.

5.3.1 Automatic Acquisition

Procedures
Automatic acquisition uses the preset guard zone as a acquisition zone to automatically
acquire a target. The guard zone is set arbitrarily.
The target which entered the guard zone is acquired automatically. The [ ▽ ] mark is
appended to the acquired target. The mark is moved together with the target and a
vector is displayed within one minute. The target within the guard zone is displayed
using the ▽ symbol and the target outside the guard zone is displayed with a normal
ATA symbol.
For the setting method, refer to subsection "5.1.1 [V] Setting the guard zone".
0°
-45° 45°
0.5NM
3.5NM
5 – 9