Loading Paper In Tray 5 (Bypass) - Xerox 2101 User Manual

2.2 Loading Paper/Changing Paper Size of Paper Trays
2.2.2

Loading Paper in Tray 5 (Bypass)

Load the following paper in tray 5 (bypass): transparency, postcard, heavy weight paper and other
special and non-standard size paper that cannot be loaded in trays 1 - 4 and the optional tray 6
(HCF).
When making copies onto SRA3 (320×450mm/12.6×17.7") or 12×18" paper, shift the paper guide on
the bypass tray before copying.
Always remember to shift the paper guide back to its Standard position after the copying is done.
● For details on the type of paper that can be loaded in tray 5 (bypass), refer to "2.1 Paper to Use".
● 2-sided copying cannot be done with tray 5 (bypass).
● For details on loading the side for copying (face up/down) and paper orientation, refer to "5.26 Copying With Covers" and
"Appendix C Originals/Copies Orientation (With Covers)".
● If the paper guide has been moved
to the 12"/305 mm or 12.6"/320 mm
position, shift it back to its Standard
position.
● Do not shift the paper guide unless
you are copying onto SRA3
(320×450mm/12.6×17.7") or 12×18"
paper. Usually, the paper guide
should be at its Standard position.
30
Procedure
1
Open tray 5 (bypass).
If necessary, pull
extension flap. The extension flap
can be pulled out in two steps.
2
Check the position of the
paper guide,
located as shown in the
diagram on the right.
Usually, the paper guide should
be at its standard position.
When loading paper:
Proceed to Step 3
When changing the paper size:
(1)Loosen the screw on
the right of the paper
guide.
out the
which is