Xerox 2101 User Manual page 263

● When the finisher is installed,
merged copy files are output to the
finisher tray as they are printed.
However, if a copy file includes
transparency separators or other
pages that cannot be output to the
finisher tray, it is automatically
output to the output tray.
● The setting for stapling or punching
specifies a position on output paper.
Set the position to a file that is
output with the face down.
● To check the document image
position after priority stapling or
punching, it is recommended to
check the results by Print First
Page.
● If the files has been programmed
with the Folding or Booklet Creation
feature, you cannot select Add
Finishing.
(2)Select file(s) to be printed.
3
Using the keypad, enter the number of copies desired and
then press Start on the control panel.
The Print File screen appears.
4
Select the print type as required.
The setting here has higher priority than that at file saving, but is not saved.
When stapling/punching:
You can set stapling or punching. If the selected file has been programmed with
the stapling or punching feature, this setting has priority over the stapling/
punching settings set at the file level
(1)Select Add Finishing.
The Add Finishing screen appears.
(2)Select a stapling or punching position.
For punch, only single position (portrait direction) can be specified.
6.6 Printing Files
233