Selecting Paper Tray; Automatically Selecting Paper Tray; Paper Supply - Xerox 2101 User Manual

This feature allows you to select a paper tray loaded with the required paper size for copying. There are two
ways to do this: the tray is automatically selected to match the document size or is manually specified.
● The factory setting for this Paper Supply feature is Auto.
● The factory setting can be changed in the Tools Mode. For details, refer to "8.3 Setting Tools Mode".
● When a paper tray runs out of paper during copying, it will switch to another tray loaded with the same paper size/ type (for
normal paper: 64-105 g/m
the Tools Mode. If all the trays are loaded with the same paper size/type (normal paper 64-105 g/m
trays will be switched in the order of trays 1, 2, 3, and 4. If the optional tray 6 (HCF) is installed, it will be switched first before the
rest of the trays.
5.3.1

Automatically Selecting Paper Tray

Auto
Based on the detected document size and the % specified in Reduce/Enlarge, a paper tray loaded with the
required paper size for copying will be selected automatically.
● When paper is not loaded in the automatically selected tray or when the document size cannot be detected, a message will be
displayed. Follow the instructions to proceed.
● When Auto % is selected for Reduce/Enlarge or Auto for Paper Supply, the document image will be rotated to fit the
orientation of the paper loaded for copying. However, this is only applicable when a standard-sized document is being copied to
a standard-sized paper smaller than A4. For non-standard paper sizes, the image cannot be automatically rotated.
● This feature is not applicable to tray 5 (bypass).
"3.2 Loading Documents"
● You cannot select Auto % for
Reduce/Enlarge and Auto for
Paper Supply at the same time. For
details, refer to "5.2 Enlarging/
Reducing Image".
92

Selecting Paper Tray

2
) and orientation to continue copying (Auto Tray Switching feature). You can specify this setting in
Procedure
1
Load the documents.
2
From Reduce/Enlarge, select the desired % except Auto %.
Check that Auto is selected for Paper Supply.

Paper Supply

2
) and orientation, the paper