Enlarging/Reducing Image; Same % For Length And Width - Xerox 2101 User Manual

This feature allows you to select a percentage (%) to enlarge or reduce your copy image. There are two ways
to specify this %: a similar or different % for the length and width of the image.
● The factory setting for this Reduce/Enlarge feature is 100%.
● The factory setting can be changed in the Tools Mode. For details, refer to "8.3 Setting Tools Mode".
● If you select Copy to Edge, you cannot select other enlargement/reduction options (Variable %, Independent X-Y %, Auto-Fit) or
with Margin Shift, Multiple Up, or Repeat Image.
5.2.1

Same % for Length and Width

There are two ways to enlarge/reduce copies with a similar % for the length and width:
• Selecting from preset %
• Specifying your own %
■
Selecting from preset %
Options available are:
Auto %
The % to enlarge/reduce the copies is automatically set based on the document size and paper size for
copying. You cannot, however, select Auto for Paper Supply.
● When Auto % is selected for Reduce/Enlarge or Auto for Paper Supply, the document image will be rotated to fit the
orientation of the paper loaded for copying. However, this is only applicable when the document is loaded in the Head to Left
orientation and the copy paper is smaller than A4 portrait.
● The image might be rotated 180 degrees when copying with stapling and punching settings.
100%
The document image will be copied in the same size (100%).
● You can fine-tune the value for 100% to between 98 and 102% in the Tools Mode. For details, refer to "8.2 Overview of Tools
Mode".
Preset %
Select from seven standard presets to enlarge/reduce a standard paper size to another standard paper
size:
%
141%
122%
115%
86%
81%
70%
50%
84

Enlarging/Reducing Image

Paper size
A4 to A3, B5 to B4
A4 to B4, A5 to B5
B4 to A3, B5 to A4
A3 to B4, A4 to B5
B4 to A4, B5 to A5
A3 to A4, B4 to B5
A3 to A5
Reduce/Enlarge