Softing smartLink HW-DP User Manual page 66

smartLink HW-DP - User Guide
4. Select PROFIdtm DPV1 from the list and confirm with [OK].
The device is displayed in the project view.
5. Open the PROFIdtm user interface and select the correct Node (Node0).
6. Right-click PROFIdtm and select Topology Scan.
7. Click the arrow in the scan window to start the topology scan.
PROFIdtm and the detected PROFIBUS devices are displayed in the scan window.
8. Close the scan window. The detected PROFIBUS device has been added to the project view.
66
Note
Before starting a topology scan ensure that suitable Device DTMs are installed for the
connected PROFIBUS devices.
Version EN-012025-1.32