Replacing The 3 1/2-Inch Internal Hard Drive - NEC PowerMate Professional 9000E Series User Manual

9. Connect the new device cables and reconnect any cables
that were disconnected to remove the cage (see
"Connecting Device Cables" and "Cabling Storage
Devices").
10. Secure the cage to the chassis with the seven screws.
11. Replace the front panel (see "Replacing the Front Panel").
12. Replace both side covers and the top cover on the system
unit (see "Replacing the Side Covers" and "Replacing the
Top Cover").
13. Run the Setup program to set the new configuration (see
"The BIOS Setup Utility" in Chapter 3).

Replacing the 3 1/2-Inch Internal Hard Drive

Your system supports two internal hard drives in the drive
cage within the chassis. You can upgrade the system by
replacing an existing hard drive, or by adding an additional
hard drive.
If the system has one hard drive, it should be located in the
top bay in the drive cage. If you are adding an additional hard
drive, install it in one of the lower three bays.
Note:
drive in a 5 1/4-inch accessible device bay. Place
the device in a 5 1/4-inch frame adapter and then
follow the instructions in "Installing a 5 1/4-Inch
Device in an Upper Bay" or "Installing a
5 1/4-Inch Device in the Lowest Bay."
You can also install a 3 1/2-inch hard
Installing Options 4-63