Replacing The Front Panel; Installing A 3 1/2-Inch Hard Drive - NEC POWERMATE VT 300 Manual

Replacing the Front Panel

Replace the front panel as follows.
:
Note
removed a 5 1/4-inch device from your system
and didn't replace it, you need to cover the
opening in the front panel with the previously
removed plastic panel.
1. Replace the blank plastic panel in the front panel if
necessary. Press the blank panel into the inside of the
front panel (over the open slot). Press until the four tabs
lock the blank panel in place.
2. Align the front panel plugs with the mounting holes in the
front of the chassis.
3. Evenly press the front panel into position until the plugs
lock the panel in place.
4. Replace the left side cover (see "Replacing the Left Side
Cover" earlier in this chapter).

Installing a 3 1/2-Inch Hard Drive

You can upgrade your system by adding a second drive or
replacing an existing hard drive. Each hard drive installs on
internal drive brackets located at the front inside of the
chassis.
:
Note
drive in a 5 1/4-inch accessible device bay. Place
the device in a 5 1/4-inch frame adapter and then
follow the instructions in "Installing a 5 1/4-Inch
Device."
4-48 Installing Options
Before replacing the front panel, if you
You can also install a 3 1/2-inch hard