Removing The Top Cover - NEC PowerMate Professional 9000E Series User Manual

3. Slide the cover forward to meet the front panel.
Note:
not slide all the way to the front panel, make sure
that the tabs along the top, back, and bottom of
the cover are aligned with the notches and rails
in the chassis.
4. Secure the cover with the three screws (see "Removing
the Side Covers").
5. If you have a chassis lock that connects to the
Kensington
the chassis.
6. If you have a padlock for the locking tab on the rear edge
of the chassis, replace it.
7. Reconnect all external peripherals.
8. Plug in the system power cables.
Repeat this procedure if the other cover must be replaced.

Removing the Top Cover

Before the accessible device cage can be removed from your
workstation, you must remove the top cover on the system
unit. Both side covers must be removed before the top cover
can be removed.
Before you remove a system unit cover, turn off
the power and unplug the system power cable.
Power is removed only when the power cable is
unplugged.
The cover fits tightly. If the cover does
®
Security Standard connector, reconnect it to
!
WARNING
Installing Options 4-9