1/4-Inch Device Removal; Optional 3 1/2-Inch Hard Drive Removal; Removing The 5 1/4-Inch Device Screws - NEC Direction SP E-Series Reference Manual

5 1/4-Inch Device Removal

Remove an optional 5 1/4-inch device from the system unit as follows.
1. Remove the system access cover, front panel, and the device cage as
previously described.
2. Label and unplug the signal and power cables from the optional device in
the 5 1/4-inch device cage. Unplug the audio cable from an optional
CD-ROM drive.
3. Remove the screws holding the device in the cage (see the following figure).
4. Slide the device out from the front of the system unit.

Optional 3 1/2-Inch Hard Drive Removal

Remove the optional 3 1/2-inch hard drive as follows.
1. Remove the system access cover and front panel as previously described.
2. Label and unplug the hard drive power and signal cables from the hard
drive.
3. Remove the two screws securing the 3 1/2-inch hard drive bracket to the
front of the system unit (see the following figure).
5-6 Disassembly and Reassembly

Removing the 5 1/4-Inch Device Screws