Standard 3 1/2-Inch Hard Disk Drive Removal; Figure 5-5 Removing The 5 1.4-Inch Device Screws - NEC Direction T-Series Manual

5-6 Section 5 Disassembly and Reassembly
3. Remove the screws holding the device in the cage (see Figure 5-5).

Figure 5-5 Removing the 5 1.4-Inch Device Screws

Slide the device out from the front of the system unit.
4.

Standard 3 1/2-Inch Hard Disk Drive Removal

Remove the standard 3 1/2-inch hard disk drive as follows.
1. Remove the system access cover and front panel as previously described.
Label and unplug the hard disk drive power and signal cables from the hard disk
2.
drive.
Remove the two screws securing the 3 1/2-inch hard disk drive to the front of the
3.
system unit (see Figure 5-6).