Running The Symbios Configuration Utility - NEC PowerMate Professional 9000E Series User Manual

Running the Symbios Configuration Utility

Use the following steps to run the Symbios Configuration
Utility.
1. Power on the system. The system boots up.
2. This message appears on the video monitor:
Press Ctrl-C to start the Symbios Configuration Utility
Press
Ctrl+C
The utility starts and the Main Menu displays.
Symbios Configuration Utility Main Menu
Port
Adapter Number
SYM53C875 F800
SYM53C875 F400
Change Adapter Status - Press Enter twice to change adapter Next Boot Status.
Adapter Boot Order - Press Enter to select and change boot order of each SCSI
adapter.
Additional Adapter Configuration - Not used.
Display Mode=Verbose - Press Enter to change display mode.
Mono/Color - Press Enter to change display from black/white to color.
Language - Not used.
Help/Quit
*Next Boot Status for this controller must be turned
MegaRAID EXPRESS(r) 762 Controller board in your system. See "Change Adapter
Status" above.
3-18 Configuring the System
to run this utility.
IRQ Status
Level
Current
11 On
10 On
if you install the optional AMI
OFF
NVRAM
Found
Next Boot*
On* Yes
On Yes