3 1/2-Inch Hard Drive Removal
The system has one internal drive bay located near the right rear of the chassis.
Upgrade the system by replacing an existing hard drive or by adding another.
Remove the 3 1/2-inch hard drive as follows.
1. Turn off the system and disconnect the system power cord.
2. Remove the system unit cover (see "Removing the Cover").
3. Label the device signal and power cables connected to the currently installed
hard drive and then disconnect them.
4. Remove the four screws securing the currently installed hard drive to the
outer wall of the chassis.
5. Remove the drive from the chassis.
\
3-24 Disassembly and Reassembly
Removing a 5 1/4-Inch Device
Removing the Hard Drive Screws