Removing An Expansion Board - NEC PowerMate Professional 9000E Series User Manual

To cable the system for Wake-On LAN do the following:
1. Connect one end of the Wake-On LAN cable to the
Wake-On LAN header on the system board.
2. Connect the other end of the cable to the Wake-On LAN
header on the 3COM 3C905B-TX board.
See "The BIOS Setup Utility" for information on configuring
your system for Wake-On LAN. See your system
administrator if you have questions about your network
configuration.

Removing an Expansion Board

To remove an expansion board, perform the following steps:
1. Remove the left cover of the system unit (see "Removing
the Side Covers").
2. Label and remove any cables connected to the expansion
board.
3. Remove the screw that secures the board to the support
bracket. Set the screw aside (use it to secure the slot cover
after the board is removed).
4. Pull the board out of the connector. Remove the board
from the expansion slot.
4-38 Installing Options