Replacing An Ip Phone 2007; Removing An Ip Phone 2007 From Service - Nortel 1110 Fundamentals

198 Nortel IP Phone 2007

Replacing an IP Phone 2007

Two IP Phones cannot share the same TN. You must remove the IP Phone 2007
that currently uses the TN.
Procedure 39
Replacing an IP Phone 2007
Step
1
2
3

Removing an IP Phone 2007 from service

Procedure 40
Removing an IP Phone 2007 from service
Step
1
2
Copyright © 2003–2007, Nortel Networks
.
Action
Obtain the node and TN information of the phone you want to
replace.
Disconnect the IP Phone 2007 that you want to replace.
Follow Procedure 34 "Configuring the IP Phone 2007" (page 182)
install and configure the IP Phone 2007.
Enter the same TN and Node Number as the IP Phone 2007 you
replaced. The system associates the new IP Phone 2007 with the
existing TN.
Action
Disconnect the IP Phone 2007 from the network or turn the power off.
The service to the PC is disconnected as well if the PC connects to
the IP Phone 2007.
If the IP Phone 2007 was automatically configured, the DHCP lease
expires and the IP address returns to the available pool.
In LD 11, enter OUT at the TN prompt.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
—End—
ATTENTION
—End—
—End—
to