First-Time Installation; Installing The Ip Softphone 2050 For The First Time - Nortel 1110 Fundamentals

234 Nortel IP Softphone 2050
5

First-time installation

During the first-time installation, the two IP address parameters entered
either manually or automatically, depending on the installation configuration.
They are as follows:
•
•
Installing the IP Softphone 2050 for the first time
Use
an IP Softphone 2050 for the first time.
Procedure 44
Configuring an IP Softphone 2050
Step
1
2
3
4
Copyright © 2003–2007, Nortel Networks
.
action, retry count, IP Phone password, node ID, and TN. Other
parameters (IP Phone IP address, subnet mask, and default
Gateway) are obtained from the DHCP server.
A DHCP server and DHCP relay agents, if required, must also be
installed, configured, and running.
Static IP address assignment
Partial DHCP
Procedure 44 "Configuring an IP Softphone 2050 " (page 234)
Action
Install the Voice Gateway Media Card. For more information, see IP
Line Fundamentals (NN43100-500).
Configure a virtual loop on the Call Server, using LD 97.
For more information, see Software Input Output Administration
(NN43001-611).
Configure the IP Softphone 2050 using LD 11. At the prompt, enter
the following
REQ: chg
TYPE: 2050PC
Install the USB Headset Adapter. If you are using the mobile
adapter, connect the headset to the adapter. If you are using the
desktop adapter, you must
a. Connect the coiled lower cord to the headset cord with the Quick
Disconnect connector. Ensure the Quick Disconnect connector
is securely fastened.
b. Connect the headset cord to the RJ9 jack on the adapter.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
—End—
to install