Nortel 1110 Fundamentals page 305

6
7
Copyright © 2003–2007, Nortel Networks
.
•
Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information about how to set up DHCP servers for use
with the IP Phones, see Converging the Data Network with VoIP
Fundamentals (NN43001-260).
At the prompt, Cached IP?, select 0 (0-No, default) to conform to the
DHCP standard and to obtain an IP address from the DHCP server.
Select 1 (1 for Yes) to force the IP Phone to start with a cached IP
address if the IP Phone cannot connect to the DHCP server and
obtain an IP address.
Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are
retrieved from the DHCP server
•
a valid IP Phone 1110 IP address
• a subnet mask
• the default Gateway for the IP Phone 1110 on the LAN
segment to which it connects
• the S1 IP (the primary CS 1000 node IP address of the IP
Phone)
• the S1 Action
•
the S1 retry count (this is the number of times the IP Phone
attempts to connect to the server)
• the S2 IP (the secondary CS 1000 node IP address of the
IP Phone)
• the S2 Action
•
the S2 retry count
• the External Application Server (XAS) IP address
b. If you select Partial DHCP, then you must enter the following
parameters.
Screen prompt
S1 IP
S1 Port
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 305
Description
The primary CS 1000 node IP
address for the IP Phone 1110.
This is a fixed value: 4100.