Installing The Ip Phone 1120E - Nortel 1110 Fundamentals

338 Nortel IP Phone 1120E
See
of the IP parameters and how they are obtained.
Table 44
IP Phone 1120E IP parameters
Parameter
VLAN ID
IP Address
Net Mask
Default Gateway Address
Connect Server (IP address, port,
action and retry count—primary and
secondary)
User ID (No de ID, Node Password
and TN)

Installing the IP Phone 1120E

To install the IP Phone 1120E, use
1120E" (page
Timing information
There are approximately 45 seconds between plugging in the IP Phone 1120E
power adapter and the appearance of the text Nortel. When you see the text
Nortel on the phone, you have 1 second to respond by pressing the four soft
keys at the bottom of the display in sequence from left to right, one at a time. If
you miss the 1-second response time, the IP Phone 1120E attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the Local diagnostic utilities to access the
IP Phone settings. See
If you are prompted to enter a password when you double-press the Services key,
password protection is enabled. For more information about password protection,
see
Copyright © 2003–2007, Nortel Networks
.
Table 44 "IP Phone 1120E IP parameters" (page 338)
Method of acquisition
Manually entered or automatically obtained through DHCP,
and LLDP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Full
DHCP.
Manually entered for first-time configuration. Obtained from
local storage on subsequent power cycles.
339).
Appendix "IP Phone diagnostic utilities" (page
"Local Tools menu password protection" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Procedure 66 "Installing the IP Phone
ATTENTION
327).
for a summary
483).