Introduction; Description - Nortel 1110 Fundamentals

390 Nortel IP Phone 1150E

Introduction

This section explains how to install and maintain the IP Phone 1150E. For
information about using the IP Phone 1150E, see the IP Phone 1150E
User Guide (NN43114-100) or the IP Phone 1150E Getting Started Card
(NN43114-101).
This section contains the following procedures
•
•
•
•
•
•
•
After you install and configure an IP Phone, if power to the phone is
interrupted, you need not re-enter the IP parameters, node number,
Terminal Number (TN), or reacquisition of firmware.

Description

The IP Phone 1150E uses the customer IP data network to communicate
with the Communication Server 1000 (CS 1000) . The IP Phone 1150E
translates voice into data packets for transport using Internet Protocol.
Use a Dynamic Host Configuration Protocol (DHCP) server to provide
information that you can use for the IP Phone 1150E network and CS
1000 connections.
The IP Phone 1150E is configured for either an Agent, or a Supervisor.
The IP Phone 1150E is shipped with Agent key configuration but can be
modified to support Supervisor key configuration by replacing the key caps.
Remove the key caps using the Key Cap removal tool (product number
NTNM19AA). For information about IP Phone 1150E components, see
"Package components" (page
Figure 43 "IP Phone 1150E default Agent key configuration" (page
391)
Copyright © 2003–2007, Nortel Networks
.
Procedure 80 "Configuring an IP Phone 1150E" (page
Procedure 81 "Installing the IP Phone 1150E " (page
Procedure 82 "Enabling Full Duplex mode" (page
Procedure 83 "Checking Ethernet Statistics" (page
Procedure 84 "Changing the TN of an existing IP Phone 1150E" (page
427).
Procedure 85 "Replacing an IP Phone 1150E" (page
Procedure 86 "Removing an IP Phone 1150E from service" (page
shows the IP Phone 1150E default Agent key configuration.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
406).
409).
416).
425).
426).
428).
429).