Nortel 1110 Fundamentals page 535

4
Copyright © 2003–2007, Nortel Networks
.
Figure 75
Sample of the 1140E.cfg file
Figure 76
Sample of the DEVICE_CONFIG file with only the [DEVICE_CONFIG]
section
Start the TFTP Server. The TFTP Server must be running on
the network when the IP Phone 1140E powers up to retrieve the
Bluetooth wireless technology administrative control. After you put
the 1140e.cfg and the device config file in the TFTP Server directory,
ensure the TFTP Server is running then reboot the IP Phone 1140E.
For information about TFTP Server configuration, see
"TFTP Server" (page
Once the IP Phone 1140E retrieves the setting when the IP Phone
1140E restarts, it is saved in persistent memory. If the Enable
BT setting is set to Auto, then the received value is acted on and
Bluetooth wireless technology is either enabled or disabled on the IP
Phone 1140E. If the Device Config file with the Enable BT setting
is not received for any reason and the Enable Bluetooth mode is
set to Auto, then the phone uses the last value received (retrieved
from persistent memory).
If administrative control is not retrieved, the previously received
value is used. If no value has ever been retrieved, then Bluetooth
wireless technology is disabled by default.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
547).
Description 535
Appendix