Nortel 1110 Fundamentals page 375

Timing information
There are approximately 45 second(s) between plugging in the IP Phone 1140E
power adapter and the appearance of the text Nortel. When you see the text
Nortel on the phone, you have 1 second to respond by pressing the four soft
keys at the bottom of the display in sequence from left to right, one at a time. If
you miss the 1-second response time, the IP Phone 1140E attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the Local diagnostic utilities to access the
IP Phone settings. See
If you are prompted to enter a password when you double-press the Services key,
password protection is enabled. For more information about password protection,
see
Procedure 74
Installing the IP Phone 1140E
Step
1
2
Copyright © 2003–2007, Nortel Networks
.
Appendix "IP Phone diagnostic utilities" (page
"Local Tools menu password protection" (page
Action
When the Nortel logo appears in the middle of the display,
immediately press the four soft keys at the bottom of the display in
sequence from left to right. The 3. Network Configuration menu
opens.
You can press the Apply&Reset soft key to save the following
settings and to reset the IP Phone. You can press the Exit soft key
exit the menu to exit the menu without saving any changes and
return to the 3. Network Configuration menu.
When the 3. Network Configuration menu opens, the Enable
802.1x (EAP) check box is highlighted.
Press the Enter key to switch this item on and off. A check mark
appears to indicate the item is active.
If 802.1x Authentication is enabled, press the Enter key to start the
edit mode. Use the dialpad to fill in the following information
• Device ID
• Password
• Retype password
For further information about 802.1x Authentication, see
"802.1x Port-based network access control" (page
If you do not enable 802.1x Authentication, you are not prompted to
enter Device ID and Password.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 375
ATTENTION
364).
483).
Appendix
469).