Replacing An Ip Phone 2004 - Nortel 1110 Fundamentals

2
3
4
5
6

Replacing an IP Phone 2004

Two IP Phones cannot share the same TN. You must remove the IP Phone 2004
that currently uses the TN.
Procedure 23
Replacing an IP Phone 2004
Step
1
2
Copyright © 2003–2007, Nortel Networks
.
During the reboot sequence of a previously configured IP Phone, the
IP Phone 2004 displays the existing node number for approximately
five seconds.
If the node password is enabled and NULL, choose one of the
following:
a. Disable the password.
b. Set the password as non-NULL.
Press OK when the node number displays.
If
the node password is enabled and
is not NULL
the node password is disabled
Enter the password at the password screen, and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference—Administration (NN43001-632).
Select the Clear soft key to clear the existing TN.
Enter the new TN.
Action
Obtain the node and TN information of the phone you want to
replace.
Disconnect the IP Phone 2004 that you want to replace.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Replacing an IP Phone 2004 129
Then
a password screen displays. Go to
Step 4.
a TN screen displays. Go to
—End—
ATTENTION
Step 5.