Figure 4-30. Removing A Fan Cable From The System Board Connector; Figure 4-31. Removing A Rivet - HP Visualize J7000 Supplementary Manual

Field Replaceable Units (FRUs)
FRU Removal and Replacement

Figure 4-30. Removing a Fan Cable from the System Board Connector

4. Each fan is attached to the inner fan wall by four plastic rivets. Using your index finger,
press on each rivet from the front side of the workstation to remove the back side of the
plastic rivets from the rivet inserts, as shown in Figure 4-31.

Figure 4-31. Removing a Rivet

5. Push the fan toward the front to release it from the rivets.
118 Chapter 4