Figure 4-19. Tie-Down Straps And Screws - HP Visualize J7000 Supplementary Manual

Figure 4-19. Tie-down Straps and Screws

T-15 Torx screws
To remove the tie-downs:
a. Remove the T-15 Torx screws securing the tie-downs to the rear air divider.
b. Remove the T-15 Torx screws from the rear panel of the workstation.
c. Rotate each tie-down out counterclockwise. The tab edge will unhinge from the fan
wall.
4. Remove the rear air divider.
5. Remove the two captive screws on the DC/DC converter unit.
6. Grasp the DC/DC converter unit by the edges and pull it straight out from the system
board.
Replacing the DC/DC Converter Units and Air Dividers
To replace the DC/DC converter units and air dividers, do the following:
1. Remove the J7000 workstation's top panel and left side panel.
2. Perform the previous removal procedure in reverse order.
NOTE The two DC/DC converter units are interchangeable. The air flow holes on
each unit should face inward to the center of the J7000's system board.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
Tie-down straps
109