Figure 4-32. Fan Air Flow Arrow; Figure 4-33. Threading The Fan Cable - HP Visualize J7000 Supplementary Manual

Replacing a System Board Cooling Fan
To replace a system board cooling fan, do the following:
1. Position the fan so that the air flow arrow on the fan, as shown in Figure 4-32, points
toward the rear of the workstation.

Figure 4-32. Fan Air Flow Arrow

2. Locate the fan cable's guide slot in the sheet metal and thread the cable accordingly, as
shown in Figure 4-33.

Figure 4-33. Threading the Fan Cable

3. Hold the fan in position flush to the inner sheet metal while aligning the fastener holes.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
119