Figure 2-1. Cd Drive Jumper Setting - HP Visualize J7000 Supplementary Manual

CD Drive (Optional) Configuration
The optional CD drive connects to the ATAPI (IDE) interface in the CD drive bay
backplane within the J5000 and J7000 workstations via a 40-pin ribbon cable, a 4-pin
audio cable, and a 4-pin power cable. No interface addressing is required for the CD drive.
However, as shown in Figure 2-1, the CD drive should have a jumper set on the C SEL
(Cable Select) selection pins. (The CD drive should ship from the factory already jumpered
for C SEL.)

Figure 2-1. CD Drive Jumper Setting

Jumpered
for C SEL
See the section titled "CD Drive (Optional)" on page 99 for details on installing a CD drive.
Chapter 2
Field Replaceable Unit (FRU) Configurations
Configuration
37