Emissions Regulations - HP Visualize J7000 Supplementary Manual

Regulatory and Safety Information
Regulatory and Safety Statements

Emissions Regulations

Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules and the Canadian Department of
Communications. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception (determined by turning the
equipment off and on), you can correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Ask the dealer or an experienced radio/television technician for help.
Hewlett-Packard's system certification tests were conducted with HP-supported peripheral
devices and HP shielded cables, such as those you receive with your computer. Changes or
modifications not expressly approved by Hewlett-Packard could void the user's authority to
operate the equipment.
Operation of this device is subject to the following conditions:
• This device may not cause harmful interference.
• This service must accept interference received, including interference that may cause
undesired operation.
• Cables used with this device must be properly shielded to comply with the requirements
of the FCC.
184 Appendix B