Figure 1-8. Floppy Disk Drive Features; Table 1-3. Floppy Disk Drive Features - HP Visualize J7000 Supplementary Manual

Floppy Disk Drive (Optional)
The J5000 and J7000 workstations support either one DDS-3 tape drive or one 3.5-inch
floppy disk drive as an optional component. (Since the DDS-3 tape drive and the floppy
disk drive use the same device bay, only one or the other can be installed.) The bay for the
floppy disk drive or DDS-3 tape drive is located on the top, left-hand side of the front panel.
The optional floppy disk drive (Product Number A5009A) is a 3.5-inch form factor device
with a PC/AT interface. It connects to the workstation via a 34-pin PC/AT ribbon cable and
a 4-pin power cable. The floppy disk drive has up to 1.44 MB capacity depending on the
media and format used.
Figure 1-8 shows the operating features of the floppy disk drive, and Table 1-3 describes
these features.

Figure 1-8. Floppy Disk Drive Features

Table 1-3. Floppy Disk Drive Features

Feature Purpose
Activity LED Flashes to indicate the floppy disk drive is
in use.
Eject Button Push to eject a floppy disk from the drive.
Chapter 1
Activity LED Eject Button
Product Information
Front Panel Components
23