Connecting To The Scsi Ports; Figure C-1 Scsi Port Connections - HP Visualize J7000 Supplementary Manual
Hp visualize j7000: supplementary guide
Hide thumbs
Also See for Visualize J7000:
- Owner's manual (246 pages) ,
- Supplementary manual (214 pages) ,
- Handbook (178 pages)
Table of Contents
Advertisement
SCSI Connections
Connecting to the SCSI Ports
Connecting to the SCSI Ports
This section describes how to connect to the workstation's NSE and LVD SCSI ports.
The J5000 and J7000 workstation contains two SCSI connectors:
• Narrow Single-Ended SCSI-2 (NSE SCSI) connector
• Ultra2 Wide Low Voltage Differential SCSI (LVD SCSI) connector
The Figure C-1 shows the two SCSI connectors on the rear panel of the J5000 and J7000
workstation. SCSI cables connect to these ports with a high-density thumbscrew connector.
Figure C-1 SCSI Port Connections
NSE connector
LVD connector
It is necessary to put a terminator on either an unused SCSI connector on the
NOTE
rear panel of the workstation, or the last device connected to the SCSI bus.
Terminators are shipped with the workstation. Be sure to use the NSE SCSI
terminator for the NSE SCSI bus, and the LVD terminator for the LVD SCSI
bus.
198
Appendix C
Advertisement
Table of Contents
Troubleshooting
