Figure 1-29 Remove the System Board Mounting Screw
Step 7. Remove the system board:
a. Grasp the memory controller chip heatsink and slide the system board toward the front of the
system. This releases the system board from its chassis standoffs.
b. Lift up the processor module side of the system board and slide it free of the PCI cage bay.
Figure 1-30 Remove the System Board
Remove Rear Chassis Port Label (rp34x0)
NOTE
This procedure applies only to an upgrade from an rp34x0 machine.
Chapter 1
HP Integrity rx2620 Upgrade
System Hardware Component Upgrade Instructions
Front of Chassis
Front of Chassis
41