HP Visualize J7000 Supplementary Manual page 141

6. Remove the four screws from the SCA hard disk interface, as shown in Figure 4-52 on
the previous page.
7. Raise the SCA hard disk interface straight up and pull outward to relieve it from the
internal chassis hooks.
Replacing the SCA Hard Disk Interface
To replace the SCA hard disk interface, do the following:
1. Remove the top panel and the right side panel from the workstation.
2. Perform the previous removal steps in reverse.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
137