Figure 4-16. Floppy Disk Drive And Filler Panel Installed In The Bracket - HP Visualize J7000 Supplementary Manual
Hp visualize j7000: supplementary guide
Hide thumbs
Also See for Visualize J7000:
- Owner's manual (246 pages) ,
- Supplementary manual (214 pages) ,
- Handbook (178 pages)
Table of Contents
Advertisement
4. Insert the floppy disk drive into the bracket and secure the drive in the bracket using
four of the six T-10 Torx screws (two on each side).
5. Install the smaller of the two filler panels on top of the floppy disk drive as shown in
Figure 4-16. Secure the filler panel with the two remaining T-10 Torx screws.
Figure 4-16. Floppy Disk Drive and Filler Panel Installed in the Bracket
6. Connect the power and ribbon cables in the drive bay to the rear of the floppy disk drive.
7. Push the DDS-3 tape/floppy disk drive bracket assembly into the drive bay, taking care
not to pinch the cables. Seat the bracket assembly flush against the front panel.
8. Insert and tighten the two T-15 Torx screws to secure the floppy disk drive to the front
panel of the workstation.
9. Replace the DDS-3/floppy disk drive EMI cover and top panel.
10.Replace the front panel bezel.
11.After rebooting, use SAM to confirm that the floppy disk drive is recognized by the
system.
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
105
Advertisement
Table of Contents
Troubleshooting
