System Board; Removing The System Board - HP Z600 Maintenance And Service Manual

System board

This section describes replacing the system board.

Removing the system board

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the rear system fan assembly (see
on page
4. Remove the memory fan assembly (see
5. Remove expansion boards and graphics cards (see
a PCI card on page
TIP: Make a note of the cable connections before disconnecting them from the system board.
For more information, refer to
6. Disconnect all cabling from the system board.
7. Prepare the chassis for system board removal.
a. Move the optical drives out of the chassis far enough to clear the system board (see
an optical disk drive from the optical bay on page
Place the optical drive and CPU power cables in the bottom optical drive bay.
Place the hard drive and front I/O cables over the chassis edge.
The following figure presents an example of these steps.
144 Chapter 5 Replacing components
122).
136).
Power connectionson page
Predisassembly procedures on page
Removing the side access panel on page
Removing the rear system fan assembly
Removing the memory fan on page
Removing a PCIe card on page
81.
92).
73).
75).
122).
133, Removing
Removing
ENWW