HP Visualize J7000 Supplementary Manual page 127

3. Remove the PCI retainer clip by pressing down on the thumb tab and pulling the clip
outward to rotate it out of the chassis floor hole, as shown in Figure 4-35 on the previous
page.
4. Determine the appropriate I/O slot for installing the I/O card. There are five PCI-2X
slots, two PCI-4X slots, and one slot for power only. The I/O slots are defined as follows:
1. Power only – Top slot
2. PCI-2X (5V, 33 MHz)
3. PCI-2X (5V, 33 MHz)
4. PCI-4X (3.3V, 66 MHz)
5. PCI-2X (5V, 33 MHz)
6. PCI-2X (5V, 33 MHz)
7. PCI-4X (3.3V, 66 MHz)
8. PCI-2X (5V, 33 MHz) – Bottom slot
NOTE Slot 1 is reserved for power only and should not be used for an I/O card. Also
note that slot 7 is the primary preferred graphics slot, and slot 4 is the
secondary preferred graphics slot.
Refer to the PCI slot label for the proper insertion location on the I/O board. The slot
numbers and voltage are identified on the I/O board.
The following are configuration guidelines for installing I/O cards in the J5000 or
J7000:
• Put graphics cards into slot 7 first and slot 4 second. A graphics card can be added to
any slot that physically has room once slots 7 and 4 are used.
Note, however, that slots 7 and 4 may be used for very high-bandwidth, general I/O
cards when not needed for graphics.
• Put I/O cards into slot 2 first, slot 8 second, slot 3 third, slot 5 fourth, and slot 6 fifth.
• Do not put any I/O card into slot 1, as that slot is reserved for power only.
CAUTION The J5000 and J7000 workstations supply about 264 Watts of power to the
PCI slots. Do not insert I/O cards that together draw more than 264 Watts, or
damage to the workstation may result.
If you install three HP V
NOTE
the HP V
imposed on the remaining I/O slots. Each of these graphics cards, while
electrically connected to only one I/O slot, takes the physical space of two
slots, and each card draws about 78 Watts. So, three of these graphics cards
will occupy six of the eight I/O slots and will draw 234 Watts altogether,
leaving only about 30 Watts for the remaining two slots combined, should
those two slots be used.
Chapter 4
ISUALIZE
Center configuration), there are some power constraints
ISUALIZE
Field Replaceable Units (FRUs)
FRU Removal and Replacement
6
FX graphics cards simultaneously (as in
123