Figure 4-50. The Flex Cable Disconnected From The I/O Board Side - HP Visualize J7000 Supplementary Manual

Field Replaceable Units (FRUs)
FRU Removal and Replacement
CAUTION Do not pull on the center of the flex cable's ejector handle, as this may bend or
break the ejector handle. Only pull on the two outer corners of the ejector
handle, as indicated by the arrows on the flex cable.

Figure 4-50. The Flex Cable Disconnected from the I/O Board Side

6. Disconnect all cables from the I/O board, including:
• Ultra2 Wide LVD SCSI cable
• NSE SCSI-2 cable
• DDS-3 tape drive/floppy disk drive cable
• Speaker cable
• Fan cable
• Power cable
• CD drive power cable and audio cable
7. Remove the two T-15 Torx screws that secure the I/O board to the rear panel of the
workstation, as shown in Figure 4-51 on the next page.
134 Chapter 4