HP Visualize J7000 Supplementary Manual page 164

Boot Console Handler
Displaying and Setting Paths
To set a system path to a new value, follow the directions in "Accessing the Boot Console
Handler" on page 150, and then type the following at the prompt:
Main Menu: Enter command > path path_type path [Enter]
where path_type is one of the path types listed in Table 5-1 and path is the specification
of the path in Mnemonic Style Notation (as described in Table 5-2). For example, to set the
primary boot path to a SCSI disk with an ID of 6.0, follow the directions in "Accessing the
Boot Console Handler" on page 150, and then type the following at the prompt:
Main Menu: Enter command > path pri scsi.6.0 [Enter]
160 Chapter 5