System Board; Removing The System Board; Installing The System Board - HP Z200 Maintenance And Service Manual

System board

This section describes replacing the system board.

Removing the system board

To remove the system board:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2.
Remove the access panel (see
3. Rotate the drive cage upward (see
4. Rotate the power supply upward (see
5.
Remove expansion boards and graphics cards (see
6. Remove the CPU heatsink (see
7. Disconnect all cabling from the system board.
TIP: Make a note of the cable connections before disconnecting them from the system board.
For more information, refer to
8.
Remove the mounting screws (1) as shown in the following figure.
Figure 5-83
9. Lift the system board slightly, and pull the board away from the rear of the chassis.
10. Lift the system board upward out of the chassis (2).

Installing the system board

To install the system board, reverse the steps for removing the board.:
ENWW
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Removing an optical drive on page
Removing the CPU heatsink on page
Cable management on page
Removing the system board
Predisassembly procedures on page
Power supply on page
Removing an expansion card on page
106.
Removing and installing components
72).
83).
114).
132).
69.
126).
137