Storage Requirements For Thermal Runaway Suppression System Equipment - Huawei Smart String ESS LUNA2000-215-2S10 User Manual

LUNA2000-(215-2S10, 215-2S12) Smart String ESS
User Manual
●
●
●
●
●
●
4.4 Storage Requirements for Thermal Runaway
Suppression System Equipment
●
●
Issue 01 (2024-07-31)
If devices are unpacked but will not be used immediately, put them back to
the original packaging with the desiccant, and seal with tape.
When temporarily storing devices outdoors, do not stack them on a pallet.
Take rainproof measures such as using tarpaulins to protect devices from rain
and water.
Storage temperature: –35°C to +60°C; relative humidity: 5%–95% RH
Do not remove the packaging. Check the packaging regularly (recommended:
once every three months). Replace any packaging that is damaged during
storage.
Do not store devices for more than two years. If devices have been stored for
two years or longer, they must be checked and tested by professionals before
being put into use.
To avoid personal injury or device damage, exercise caution when stacking
devices to prevent them from falling over.
At room temperature (about 25°C), charge the backup battery of the thermal
runaway suppression system equipment at least once every six months. The
charge interval is halved for every 10°C increase in temperature.
When the thermal runaway suppression system equipment is stored as spare
parts, the ambient temperature shall range from 0°C to 50°C and the
humidity shall be less than or equal to 95% RH.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Storage Requirements
66