Huawei Smart String ESS LUNA2000-215-2S10 User Manual page 68

LUNA2000-(215-2S10, 215-2S12) Smart String ESS
User Manual
Material Delivery Check
There must be a battery charge label on the packing case. The charge label must
specify the latest charge time and the next charge time.
Storage Requirements
● Ensure that batteries are stored in a dry, clean, and ventilated indoor
● If a battery is faulty (with scorch, leakage, bulge, or water intrusion), move it to
● Place batteries correctly according to the signs on the packing case during
● Store batteries in a separate place. Do not store batteries together with other
● After batteries are powered off, static power consumption and self-discharge
It is recommended that batteries be used soon after being deployed onsite.
Batteries that have been stored for an extended period shall be charged
periodically. Otherwise, they may be damaged.
●
Issue 01 (2024-07-31)
WARNING
environment that is free from sources of strong infrared or other radiations,
organic solvents, corrosive gases, and conductive metal dust. Do not expose
batteries to direct sunlight or rain and keep them far away from sources of
heat and ignition.
a dangerous goods warehouse for separate storage. The distance between the
battery and any combustible materials must be at least 3 m. The battery must
be scrapped as soon as possible.
storage. Do not place batteries upside down, lay them on one side, or tilt them.
Stack batteries in accordance with the stacking requirements on the packing
cases.
devices. Do not stack batteries too high. The site must be equipped with
qualified fire fighting facilities, such as fire sand and fire extinguishers.
loss may occur in internal modules, which may cause battery damage due to
overdischarge. Do not store batteries in low SOC and charge batteries in a
timely manner. Permanent battery faults caused by delayed charge are not
covered by the warranty. Storing the batteries in low SOC occurs in scenarios
including but not limited to the following:
● The power cables or signal cables are not connected.
● The batteries cannot be charged due to a system fault after discharge.
● The batteries cannot be charged due to incorrect configurations in the
system.
● The batteries cannot be charged due to long-term mains failure.
● The batteries cannot be charged because the switch of the Smart Rack
Controller, Smart PCS, or main loop component is off.
CA UTION
Packaging label description
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Storage Requirements
61