A Crimping An Ot Or Dt Terminal - Huawei Smart String ESS LUNA2000-215-2S10 User Manual

LUNA2000-(215-2S10, 215-2S12) Smart String ESS
User Manual
A
Requirements on an OT or DT Terminal
●
●
●
● Do not connect aluminum wiring terminals to the terminal block. Otherwise
● Comply with the IEC 61238-1 requirements when using copper-to-aluminum
● Do not mix up the aluminum and copper sides of a copper-to-aluminum
Issue 01 (2024-07-31)
Crimping an OT or DT Terminal
If a copper cable is used, use copper wiring terminals.
If a copper-clad aluminum cable is used, use copper wiring terminals.
If an aluminum alloy cable is used, use copper-to-aluminum wiring terminals,
or aluminum wiring terminals along with copper-to-aluminum washers.
NO TICE
electrochemical corrosion may occur, affecting the reliability of cable
connections.
wiring terminals, or aluminum wiring terminals along with copper-to-
aluminum washers.
washer. The outer contour of the washer shall not be smaller than that of the
OT/DT terminal. Ensure that the aluminum side of the washer contacts the
aluminum wiring terminal, and that the copper side contacts the terminal
block. It is recommended that washers and terminals be purchased from the
same vendor.
Copyright © Huawei Digital Power Technologies Co., Ltd.

A Crimping an OT or DT Terminal

114