Figure 5-3. Installing DIMM into Slot
To Install: Insert module vertically and press down until it snaps into place. Pay attention to the
bottom notch.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from the
slot.
Adding PCI Cards
PCI Expansion Slots
Two riser cards are used to support add-on cards to the system. The StorTrends 1300 chassis can
accommodate one standard size (full height full length) and one low profile PCI expansion card.
When viewed from the chassis front, the standard size card installs to the left and the low-profile
card installs to the right side.
PCI cards are installed into riser cards that have been pre-installed to the system. An additional
two riser cards are included to support PCI-E add-on cards.
62
StorTrends® 1300 User's Guide (StorTrends iTX version 2.7)