Table of Contents
Advertisement
Figure 6-1. Chassis: Front and Rear Views
Slim DVD-ROM Drive
Power Supply Module
Mouse/Keyboard
Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1
connector on the server board to provide you with system status indications. These wires
have been bundled together as a ribbon cable to simplify the connection. Connect the
cable from JF1 on the server board to the appropriate header on the Control Panel PCB
(printed circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull
all excess cabling out of the airflow path.
The control panel LEDs inform you of system status.
System Fans
Three 4-cm heavy duty counter-rotating fans provide the cooling for the StorTrends 1300.
Each fan unit is actually made up of two fans joined back-to-back, which rotate in
opposite directions. This counter rotating action generates exceptional airflow and works
to dampen vibration levels. It is very important that the chassis top cover is properly
installed and making a good seal in order for the cooling air to circulate properly through
the chassis and cool the components.
76
StorTrends® 1300 User's Guide (StorTrends iTX version 2.7)
SATA Drive Bays
USB Ports
COM1 Port
VGA Port
System LEDs
System Reset
PCI Expansion Slots (w/ riser cards)
Ethernet Ports
Control Panel
Main Power
Advertisement
Table of Contents
