Table of Contents
Advertisement
Control Panel LEDs
The control panel located on the front of the StorTrends 1300 chassis has five LEDs. These LEDs
provide you with critical information related to different parts of the system. This section explains
what each LED indicates when illuminated and any corrective action you may need to take.
Illustration
Name
Universal Information
LED
NIC2 LED
NIC1 LED
HDD LED
Power LED
Universal Information LED States
State
Fast Blinking Red (1x/sec)
Solid Red
Slow Blinking Red (1x/4sec)
Solid Blue
Blinking Blue
Note:
Deactivating the UID LED must be performed in the same way it was activated. (If the UID LED
was activated via IPMI, you can only turn the LED off via IPMI and not with the UID button.)
44
StorTrends® 1300 User's Guide (StorTrends iTX version 2.7)
Description
When this LED blinks red quickly, it indicates a fan failure and when
blinking red slowly a power failure. This LED will be blue when used for
UID (Unit Identifier). When on continuously it indicates an overheat
condition, which may be caused by cables obstructing the airflow in the
system or the ambient room temperature being too warm. Check the routing
of the cables and make sure all fans are present and operating normally. You
should also check to make sure that the chassis covers are installed. Finally,
verify that the heatsinks are installed properly. This LED will remain flashing
or on as long as the indicated condition exists. See the table below for
descriptions of the LED states.
Indicates network activity on LAN2 when flashing.
Indicates network activity on LAN1 when flashing.
Indicates IDE channel activity. On the StorTrends 1300 this light indicates
SAS and/or DVD-ROM drive activity when flashing.
Indicates power is being supplied to the system's power supply units. This
LED should normally be illuminated when the system is operating.
Indication
Fan Fail
CPU Overheat
Power Fail
Local UID Button Depressed
IPMI-Activated UID
Advertisement
Table of Contents
